Programming Instructions; User Codes - CODELOCKS CL2000 Programming And Operating Instructions

Programming Instructions

*First change the factory Master Code
the Master or Sub-Master Code is entered 3 times consecutively
without performing a programming function, a penalty time of 10
seconds is activated.
Note: On the CL2000 and CL4000 locks the
the bottom of the keypad acts as the # button. The Master Code and
Sub-Master Code MUST always start with #. Codes can only be the
same length as the Master Code. A • or • in the Key Sequence
opposite indicates LED illumination.
# 1234 - see program 10. If
at
Page 4
Find more online at www.codelockssupport.com
Changing key bypass functions
Storeroom Function tailpiece allows key to turn 90° clockwise to
enable handle to retract the latch - this is the factory fitted function.
Classroom Function tailpiece allows key to turn 90° clockwise and
be removed leaving the handle engaged in Code Free Mode. Code
Free Mode is cancelled by turning key 90° anti-clockwise.
THESE TAILPIECES WILL FIT MOST SCREW-CAP CYLINDERS
FROM OTHER MANUFACTURERS

User Codes

Enter new User Code - Program 01
#Master Code 01 User Code ID (eg 05) New Code (eg 4321) • •
Result : New code 4321 entered at User Code ID 05 ( when user
enters code)
Suspend User Code - Program 02
#Master Code 02 User Code ID (eg 05) • •
Result: User Code at ID 05 suspended ( when user 05 enters
code)
Restore User Code - Program 03
#Master Code 03 User Code ID (eg 05) • •
Result: User Code at ID 05 restored (• when user 05 enters code)
• ••
•
••
••
••