Table of Contents
Advertisement
Quick Reference Table
Multiple Quatro's
1. Fasten the effect light onto firm trussing (Use a 30-kg rated or stronger C-clamp fastened onto the
Quatro ). Leave at least 1 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the Quatro's and other devices.
The pins:
3. Link the units as shown, Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4. Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the other
end of the mains power cord into proper electric power supply sockets, starting with the first unit. Do
not supply power before the whole system is set up and connected properly.
DMX-Set up
Master/Slave Set up
Note : Link all cables before connecting electric power
1.
Earth
2.
Signal -
3.
Signal +
Multiple Quatro's Set Up
8
Fig. 4
Advertisement
Table of Contents
