Camera Adjustment - Samsung VP-MX10 Service Manual

Troubleshooting

4-2-2 Camera Adjustment

Note: When you replace ASSY-CAMERA or PCB BORAD, you need to adjust each part again, due to
the fact that EEPROM remembers the confirmed adjustment value. Therefore,
re-adjustment is necessary for data-saving when replacing.
- The part that needs re-adjustment after replacing Lens Ass'y or PCB BOARD.
Auto Hall
q
Auto Iris
w
Auto Lens 3m
e
Zoom VR Check
r
Auto White Balance (3100K)
r
Auto White Balance (5100K)
t
1. Auto HALL adjust
The camera should be in "E-E" mode (Video Record).
q
Connect the AV cable to Input port of Monitor or TV.
w
After entering the Admin mode, press the OK button in "Set Adjust" menu.
e
Press the OK button in "Camera & CDS adjust" menu.
r
Press the OK button in "Auto adjust" menu.
t
Press the OK button by finding Hall with the UP/DOWN button.
y
(HALL is set basically.)
In this case,
u
- DSP opens IRIS and finds the highest value of HALL.
- DSP closes IRIS and finds the lowest value of HALL and stores data value.
"Adjustment completed!" displays after finishing Hall Adjust. Finish it by pressing the OK button.
i
2. Auto IRIS level adjust
The camera should be in "E-E" mode (Video Record, Photo Capture).
q
Connect the AV cable to Input port of Monitor or TV.
w
After entering the Admin mode, press the OK button in "Set Adjust" menu.
e
Press the OK button in "Camera & CDS adjust" menu.
r
Press the OK button in "Auto adjust" menu.
t
Press the OK button by finding IRIS adjust with the UP/DOWN button.
y
In this case,
u
- DSP opens IRIS and finds the highest value of IRIS.
- DSP closes IRIS and finds the lowest value of IRIS and stores data value.
Adjustment completed!"displays after finishing adjust. Finish it by pressing the OK botton.
i
4-0 Samsung Electronics