Schematic Diagrams; All Block Diagram - Samsung VP-MX10 Service Manual

7. Schematic Diagrams

7-1 All block Diagram ----------------------------------------------------------------------------------------7-2

7-2 System ----------------------------------------------------------------------------------------------------------7-3
7-3 Motor hall/iris (Main PCB) --------------------------------------------------------------------------7-4
7-4 CDS (Main PCB) --------------------------------------------------------------------------------------------7-5
7-5 DSP (Main PCB) --------------------------------------------------------------------------------------------7-6
7-6 PR8188 (Main PCB) --------------------------------------------------------------------------------------7-7
7-7 SDRAM Nor Flash (Main PCB) ---------------------------------------------------------------------7-8
7-8 Nand (Main PCB) ------------------------------------------------------------------------------------------7-9
7-9 Encoder/Decoder (Main PCB) -------------------------------------------------------------------7-10
7-10 LDR (Main PCB) ----------------------------------------------------------------------------------------7-11
7-11 Audio (Main PCB) -------------------------------------------------------------------------------------7-12
7-12 USB (Main PCB) ----------------------------------------------------------------------------------------7-13
7-13 Syscon (Main PCB) -----------------------------------------------------------------------------------7-14
7-14 DC/DC (Main PCB)------------------------------------------------------------------------------------7-15
7-15 DC/DC Waveform (Main PCB) -----------------------------------------------------------------7-16
7-16 Charge (Main PCB) -----------------------------------------------------------------------------------7-18
7-17 SD/MMC+ Socket (Main PCB) -----------------------------------------------------------------7-19
7-18 EIS (Main PCB) -----------------------------------------------------------------------------------------7-20
7-19 AV Out (Main PCB) -----------------------------------------------------------------------------------7-21
7-20 Main 60Pin (Main PCB) ----------------------------------------------------------------------------7-22
7-21 Sub-1 (Sub PCB) ---------------------------------------------------------------------------------------7-23
7-22 Sub-2 (Sub PCB) ---------------------------------------------------------------------------------------7-24
7-23 LCD (LCD PCB) ------------------------------------------------------------------------------------------7-25
7-24 Rear (Rear PCB) ---------------------------------------------------------------------------------------7-26
7-25 CCD (CCD PCB) -----------------------------------------------------------------------------------------7-27
7-26 Zoom (Zoom PCB) ------------------------------------------------------------------------------------7-28
7-27 FPC LCD (FPC LCD PCB) ---------------------------------------------------------------------------7-29
7-28 FPC GYRO (FPC GYRO PCB) ---------------------------------------------------------------------7-30
Samsung Electronics
Samsung Electronics
● For schematic Diagram
- Resistors are in ohms, /8W unless otherwise noted.
Special note :
Most semiconductor devices are electrostatically sensitive and therefore require the special handling techniques
described under the "electrostatically sensitive (ES) devices" section of this service manual.
Note :
Do not use the part number shown on this drawing for ordering. The correct part number is shown in the parts list
(may be slightly different or amended since this drawing was prepared).
Important safety notices :
Components identified with the mark
components. Use only the same type.
This Document can not be used without Samsung's authorization This Document can not be used without Samsung's authorization
Note
have the special characteristics for safety. When replacing any of these
7- 7-