Samsung VP-MX10 Service Manual page 39

Troubleshooting
5. Auto White Balance adjust (3100K)
The camera should be in "E-E" mode (Video Record).
q
Prepare the gray scale chart of 3100°K.
w
Connect the AV cable to Input port of vector scope and TV.
e
Press the OK button after entering "Set Adjust".
r
- Press the OK button in "Camera & CDS adjust" menu.
- Press the OK button in "Auto adjust" menu.
Make the camera situated in 40ms to the 3100°K gray scale chart and make the intensity of
t
illumination 1500 ~ 2000 Lux.
- Press the OK button by finding "WB 3100" with the UP/DOWN button.
Check the white point comes to the center of display at the vector scope.
y
After entering the adjust mode, press the OK button in "Adjustment completed!" menu.
u
6. Auto White Balance adjust (5100K)
The camera should be in "E-E" mode (Video Record).
q
Prepare the gray scale chart of 5100°K.
w
Connect the AV cable to Input port of vector scope and TV.
e
Press the OK button after entering "Set Adjust".
r
- Press the OK button in "Camera & CDS adjust" menu.
- Press the OK button in "Auto adjust" menu.
Make the camera situated in 40ms to the 5100°K gray scale chart(3100°K gray scale chart+C16 filter)
t
and make the intensity of illumination 1500 ~ 2000 Lux.
- Press the OK button by finding "WB 5100" with the UP/DOWN button.
Check the white point comes to the center of display at the vector scope.
y
After adjust, finish the OK button and "Adjustment completed!" displays. Finish it by pressing the OK
button.
Adjustment completed!"displays after finishing 5100K Adjust. Finish it by pressing the OK botton.
u
4- Samsung Electronics