Samsung VP-MX10 Service Manual page 38

3. Auto LENS control
Caution : For whole zoom range, it shall be in focus. The location of a focus lens is moving depending on the location of
Zoom Lens. During Adjusting, micom measures the focus location from a near distance to a long.
The camera should be in"E-E" mode (Video Record).
q
Make the focus chart.
w
Ensure that camera is left an about 3m distance from a focus chart and the focus of lens
e
is placed vertically. Attatch a focus chart to white or gray wall of a flat surface.
Connect the AV cable to Input port of Monitor or TV.
r
Press the OK button after entering "Set Adjust".
t
- Press the OK button in "Camera & CDS adjust" menu.
- Press the OK button in "Auto adjust" menu.
- Press the OK button after finding "Lens 3m" with the UP/DOWN
button.
- Don't force the zoom and focus lens when adjust.
After Lens adjust, finish the OK button and "Adjustment completed!" displays. Finish it by pressing
y
the OK button.
4. Zoom VR Check
Connect the AV cable to Input port of vector scope and TV.
q
Press the OK button after entering "Set Adjust".
w
- Press the OK button in "Camera & CDS adjust" menu.
- Press the OK button in "Auto adjust" menu.
- Press the OK button by finding "Zoom VR Check" with the UP/DOWN button.
Then Micom finds out Zoom VR Center position. Store Zoom VR Center Value
e
Adjustment completed!"displays after finishing VR check. Finish it by pressing the OK botton.
r
Samsung Electronics
Fig. 4-
Troubleshooting
4-