Cloning Radio Using The Radio To Radio (R2R) Cloning Cable (Optional Accessory); Operating Instructions - Motorola RDU4160d User Manual

Cloning Radio using the Radio to Radio
(R2R) Cloning Cable (Optional Accessory)

Operating Instructions

1. Before starting the cloning process, make sure
you have:
• A fully charged battery on each of the radios.
• Two Single-Unit Chargers (SUC).
• Turn OFF the radios and,
• Both radios are of the same radio model.
2. Unplug any cables (power supply or USB
cables) from the SUCs.
3. Plug one side of the cloning cable mini USB
connector to the first SUC and the other end to
the second SUC.
Note: During the cloning process, no power is
being applied to the SUC. The batteries will
not be charged. Only data communication is
being established between the two radios.
4. Turn ON the Target Radio and place it into one
of the SUCs.
5. For the Source Radio, power ON the radio with
the following sequence:
• Long press the PTT button and SB2
simultaneously while turning the radio ON.
• Wait for 3 s before releasing the buttons until a
distinctive audible tone is heard.
6. Place the Source radio in its SUC, press and
release SB1.
7. After cloning is completed, the Source radio will
sound either a 'pass' tone (cloning was
successful) or a 'fail' tone (cloning process has
failed). The 'pass' tone sounds like a good key
55
English