Method 2: Direct Attach; Procedure - HP ML110 G1 User Manual

3. Open Internet Explorer on the PC. Enter https://, the serial number
of the storage server followed by a hyphen (-), and then:3202. Press
Enter.
Example: https://D4059ABC3433-:3202
NOTE:
Substitute the server name for the serial number if a server name
was previously set.
4.
Login to the WebUI. This launches the WebUI configuration
application (Rapid Startup) on the target HP ProLiant Storage Server,
as shown in
NOTE:
The default login for the WebUI is administrator and the
password is hpinvent. The WebUI uses the same login as the local
administrator's account or an account with administrative privileges.
5. Go to
procedures.

Method 2: Direct attach

You can access the WebUI using a monitor, mouse, and keyboard directly
attached to the storage server.

Procedure

1.
Connect the Ethernet cable to the network port of the storage server
and the corresponding network segment.
2.
Connect the monitor, mouse, and keyboard directly to the rear panel
connectors of the storage server.
3.
Power on the storage server.
4. Login into the device using the WebUI user name and password.
Figure 1.
Rapid Startup Wizard configuration
HP ProLiant Storage Server user guide
to complete the setup
25