Direct Attach Method; Requirements; Procedure - HP StorageWorks 4000s - NAS Installation Manual

Direct attach method

You can access the WebUI using a monitor, mouse, and keyboard
directly attached to the NAS device.

Requirements

The following items are required to run the WebUI configuration
application:
Monitor
Mouse
Keyboard

Procedure

To initialize the NAS device:
1. Connect the Ethernet cables to the respective network ports
of the NAS device and the corresponding network segments.
2. Connect the monitor, mouse, and keyboard directly to the rear
panel connectors of the NAS device.
3. Open Internet Explorer and click Yes in the Security Alert
dialog to accept the security certificate. This launches the
WebUI configuration application (Rapid Startup) on the
target StorageWorks NAS device, as shown in
WebUI does not launch connect to the LocalHost and login to
the WebUI
Note:
password is hpinvent. The WebUI uses the same login as the local
administrator's account or an account with administrative privileges.
4. Go to the
complete the setup procedures.
26
DRAFT
The default login for the WebUI is Administrator and the
"Rapid startup wizard
HP Restricted
configuration" on page 27 to
NAS 4000s and 9000s Installation Guide
Figure 4. If the