E Ascii Command Guide - Wyse WY-60 User Manual

AppendIx
E
ASCII Command Guide
--------------------------_.
__
._._.
-,
-----,-,-
COMMANDS SUPPORTED IN
ASCII PERSONALITIES
Table E-1 lists the ASCII commands recognized by the terminal
in native, Wyse WY-50+, ADM 31, ADDS VP A2, ADDS VP
60, HZ 1500, IBM 3101, and IBM 3161 personalities.
Table E-2 lists the ASCII commands recognized by the terminal
in native, DG 200, DG 210, TeleVideo
910+/920/9251950/955,
and PC Term personalities.
The native personality code for the command is given in the
second column. The remaining columns show the support for the
command in other ASCII personalities according to the following
notations:
Same
Same as native code (code is native to other terminal also)
Wyse
Same as native code (Wyse enhancement-code not native to
other terminal)
ENH
Same as native code when enhance mode is on (Wyse
enhancement-code not native to other terminal)
A code listed under a nonnative personality indicates that the
related terminal's native code is supported. These codes are
given in abbreviated form. Refer to the other terminal's
documentation for complete information on the indicated
command and its associated parameter values. A blank in any
column indicates that the command is not supported in that
personality.
Variables are shown in italics. The variable values for both
Tables E-1 and E-2 are given at the end of Table E-2 according
to the reference numbers in brackets after the command
description, e.g, [22].
ANSI commands (recognized by the terminal in the WY-75,
VT52, and VT100 personalities) are listed in Appendix F.