F Ansi Personalities - Wyse WY-60 User Manual

Appendix
F
ANSI Personalities
Table F-1 ANSI Commands
Function
Communicating with the Computer
Send ACK/answerback message
This appendix describes the commands supported in the
terminal's ANSI personalities: WY-75 , VT52, and VT100.
The command descriptions assume a basic working knowledge of
ANSI-based terminals.
Table F-1 lists the commands under functional headings. Within
a command sequence, parameters are underlined:
Pn
represents
a numeric parameter; Ps represents a selective parameter whose
values are listed immediately following the command. Table F-2
lists mnemonic names. Tables F-3 through F-6 list key codes.
Mnemonic
Command Sequence
WY-75NT100
VT52
Resume transmission (after suspension by CTRL S)
Suspend transmission (when transmit handshaking
is Xon/Xoff)
ENQ
DCl
DC3
CTRLE
CTRLQ
CTRL S
CTRLE
CTRLQ
CTRL S
Delay processing for about 250 milliseconds
Request terminal ID
WYDELAY ESC,
WYID ESC SPACE
Response (WYID):
75 CR (WY-75 personality)
60 CR (all other personalities)
Request status report
Ps Request
5 Terminal status
6 Cursor position
?15 Printer status
DECID ESC Z
DA ESC [0 c
Response (DECID or DA):
ESC [ ? 1 ; 0 c (WY-75 personality)'
ESC [ ? 1 ; 2 c (VT100 personality)2
ESC / Z (VT52 personality)
DSR ESC [Ps n
Report
Ready: ESC [ 0 n
Line/column: ESC [ Pn;Pn R
Ready: ESC [ ? 10 n
Busy: ESC [ ? 11 n
1. Mode without AVO. Attributes are nonhidden in WY-75 personality.
2. Mode with AVO. Attributes are hidden in VT100 (and VT52) personality.
ESCZ