Wyse WY-60 User Manual page 19

Configuring the Terminal 2-9
Table 2-2 Setup Parameters, Continued
Level
COMM, Continued
Miscellaneous (IBM
Personalities)
,4
Parameter
RCV HNDSHAKE"
NONE
XON/XOFF
DTR
BOTH
XMT HNDSHAKE
NONE
XON/XOFF
XPC HNDSHAKE
OFF
ENTER
SEND
RETURN
INSERT'5
MODE
SPACE
PRINT'5
VIEWPORT
SCREEN
PRINT EOL,5
ON
OFF
13. RCV Handshake parameter must be set to XonlXoff.
14. Parameters displayed when the terminal is in an IBM personality.
15. IBM 3161 only.
Explanation
The terminal controls the flow of data received from a
device connected to the MODEM port by
No handshaking protocol
Software handshaking-CTRL S (Xoff) and CTRL Q
(Xon) control codes
Hardware handshaking (raising and lowering the DTR
line voltage)
Both hardware (DTR) and software
(Xon/Xoff)
handshaking
The terminal regulates the sending of data to a device
connected to the MODEM port by responding to
Hardware handshaking only (DSR line)
Software handshaking-CTRL S (Xoff) and CTRL Q
(Xon) control codes
When the terminal is in PC Term personality,
The receive handshaking protocol depends on the
RCV Hndshake parameter setting of the port
configured as the data port
Special codes (Hex 65 and Hex 67) are sent in place
of Xon/Xoff handshaking protocol for the port
configured as the data port
Pressing
I
Enter
I
sends code defined by the
Send parameter
Return parameter (in this setup level)
Pressing
I
Insert
I
Turns on insert mode
Inserts a space character at the cursor position (cursor
doesn't move)
Pressing
I
Print
I
sends to the printer the contents of the
Viewport
Screen
When the terminal executes print viewport, print screen,
or print page commands,
The line terminator defined by the Print Line End
parameter is sent to the printer
No line terminator is sent