Wyse WY-60 User Manual page 14

2-4 Chapter 2
Table 2-2 Setup Parameters, Continued
Level
Display, Continued
General
Parameter
SCRL SPEED
JUMP
SMOOTH-8
SMOOTH-4
SMOOTH-2
SMOOTH-l
SCRN SAVER
ON
OFF
STATUS LINE
STANDARD
EXTENDED
OFF
AUTOSCRL
ON
OFF
COMM MODE
FULL DUPLEX
BLOCK
HALF DUPLEX
HALF BLOCK
DATA/PRINTER
MODEM/AUX
AUX/MODEM
END-OF-LINE WRAP
ON
OFF
ENHANCE
ON
OFF
FONT LOAD
ON
OFF
Explanation
The display scrolls
At the rate data is received
Eight lines per second
Four lines per second
Two lines per second
One line per second
If
the terminal receives no data for approximately 15
minutes,
The screen blanks until you press a key (no data is
lost) .
Screen data displays continuously
The screen displays
A status line with time and cursor line and column
indicators
A status line with editing status messages
No status line
When the cursor moves past the last line of the page,
The data scrolls up one line
It returns to the top of the same page
The terminal's communication mode is
Full duplex
Block
Half duplex
Half-duplex block
The terminal communicates with the computer through the
MODEM port (AUX port is the printer port)
AUX port (MODEM port is the printer port)
When additional characters are entered at the end of a
line,
The cursor wraps to the start of the next line
Characters at the cursor position are replaced
In some nonnative terminal personalities, an enhanced set
of codes is
Recognized by the terminal
Not recognized by the terminal
When changing personalities or the number of displayed
lines, the terminal
Loads the appropriate character set
Doesn't change the current character set