Alarm Clock - Wyse WY-60 User Manual

ALARM CLOCK
Alarm Clock Display
Setting the Alarm
WyseWorks
Error Messages
If
your calculation exceeds 14 digits or if a number has been
divided by zero, an error message appears on the top line of the
screen (the status line):
**Number too large**
**Division by zero**
If
this happens, clear the calculation and recalculate.
In the alarm clock accessory you can set two alarm times and
enter two 20-character reminder messages. At the set ~ime, the
alarm sounds for 30 seconds, and any reminder message is
simultaneously displayed on the status line.
D
Note The alarm sounds only during normal terminal operation,
not while the terminal is in WyseWorks or setup mode.
The alarm clock display shows
4-5
• The current time according to the terminal's clock (default
8:00 a.m.)
• Two alarm setting lines-Alarm 1 and Alarm 2-each with a
time field (default 12:00 a.m.), a 20-character message field,
and an on/off indicator field
Position the cursor in the appropriate fields:
1 Press the cursor keys or
~
or
1 Backspace
1
to go from field
to field. Pressing
1
Return
1
(I
Enter
I)
moves the cursor to the
start of a line.
2 To reset the terminal's clock, enter the current time (12-hour
format, including a.m. or p.m.) in the time field.
3 Enter the desired alarm time in the Alarm 1 or Alarm 2 time
field and the desired message in the message field.
4 In the on/off indicator field, press any key to set the alarm
bell to
on.
D
Note After the alarm sounds, the indicator defaults to off, but
the time setting and message remain until you redefine them or
turn off the terminal.