Setting Ip Addresses Of Ae-200 - Mitsubishi AE-200A Instruction Book

4-3-2. Setting IP addresses of AE-200

Set the AE-200 IP address and the expansion controller connection.
[1] AE-200 initial start-up for a system without connection to an AE-50/EW-50 controller
(1) After the power is turned on, a language selection screen will
appear.
Select the language to be used for display, and then touch [OK].
Note: It will take approximately one minute for the display to appear
after the power is turned on.
Note: Do not touch the LCD before any settings screen appears.
Note: Once the initial settings have been made, [Monitor/Operation]
screen will appear after the power is turned on.
(2) Touch the [Unit Info.] and [Unit Info. 2] tabs.
Referring to section 5-1-4 "Unit Information", make necessary
basic settings, and then touch [Save Settings].
Note: Make sure to set the [System Exp] setting for the AE-200 to [Do
not expand].
Note: Make sure to set the [AE-200 M-NET] setting to [Use].
[2] AE-200 initial start-up for a system with connection to one or more AE-50/EW-50 controllers
(1) After the power is turned on to the AE-200, a language
selection screen will appear.
Select the language to be used for display, and then touch [OK].
Note: It will take approximately one minute for the display to appear
after the power is turned on.
Note: Do not touch the LCD before any settings screen appears.
Note: Once the initial settings have been made, [Monitor/Operation]
screen will appear after the power is turned on.
WT07627X03
Unit Info.
Unit Info. 2
26