Energy Management Block Settings - Mitsubishi AE-200A Instruction Book

6-4-5. Energy management block settings

Make the settings for the energy management block (tenant) used as collective unit for the apportioned electricity
billing function.
[1] General descriptions
(1) What is energy management block (tenant)?
• An energy management block (tenant) is the unit used for displaying and outputting charge calculation
results.
• An energy management block (tenant) is a collection of operation blocks.
• An operation block is a collection of groups.
AE-200 EW-50
(2) LOSSNAY (including OA Processing unit) settings
Make the settings based on the LOSSNAY system configuration.
LOSSNAY
OA Processing unit
WT07627X03
Energy management block
Operation block
Group
Operation block
Group
Usage
When not interlocked with the operation of
indoor units
When interlocked with the operation of
indoor units
When not interlocked with the operation of
indoor units
When When interlocked with
interlocked with the operation of same
the operation of tenant's indoor units
indoor units
When interlocked with
the operation of multiple
tenants' indoor units
Group
Energy management block setting method
To apportion the electric energy, set as energy
management block (tenant). (See [2] (3).)
No settings are required (cannot be set as a target
for billing function).
Note: The LOSSNAY electric energy will be
Set as energy management block (tenant). (See [2]
(3).)
Set as same energy management block (tenant)
as the interlocked indoor units. (See [2] (6).)
Make the settings in one of the following ways:
<Method 1>
Set as independent energy management block
(tenant) and invoice the electricity charges by
including it to common area charges, etc. (See [2]
(6).)
<Method 2>
Exclude these units from the tenant settings.
In this case, the electric energy for OA Processing
units will be apportioned based on the operating
status of the interlocked indoor units.
110
apportioned based on the operating status
of the interlocked indoor units.