Date And Time Setting - Mitsubishi AE-200A Instruction Book

4-2. Date and time setting

Set the date and time for the AE-200/AE-50/EW-50. There are two ways to set the date and time — from the AE-200's
LCD, and individually from the AE-200/AE-50/EW-50 Web Browser for Initial Settings.
If an expansion controller is connected in an AE-200 system, connect the AE-200 to the expansion controller over
a LAN, then set the date and time from the AE-200. Setting the date and time on the AE-200 will synchronize the
date and time on the expansion controller with the AE-200, therefore setting the date and time on the expansion
controller is not necessary.
Note: After the "Integrated Centralized Control Web" license is registered, the date and time can be set on the Integrated
Centralized Control Web. For details, refer to [Settings] – [Initial settings] – [Date and Time Settings] in the Instruction Book
(Integrated Centralized Control Web).
[1] When setting date and time on the AE-200's LCD
(1) Touch the [Date and time] tab.
Referring to section 5-1-3 "Date and time", set the current date,
current time, and daylight saving time, and then touch [Save
Settings].
Note: The AE-200's current date and time will be synchronized to
each AE-50/EW-50 and remote controllers.
Note: In order to synchronize the date and time with the
AE-50/EW-50, it is necessary to set the date and time.
Note: The setting will not be saved until [Save Settings] is touched.
Make sure to touch [Save Settings] after the setting is
completed.
WT07627X03
19