Pepperl+Fuchs OBD10M-R2000-4EP Manual page 12

2-D Laser Scanner
Commissioning
EN
10 - EN
DHCP
Set the device to DHCP under the "Address mode" menu item. The DHCP
configuration requires a DHCP server in the local network, e.g., a router. See the
"Auto IP" item for information on this.
Manual IP
Set the device to manual under the "Address mode" menu item. The IP address is
set to 10.0.10.9 and the subnet mask to 255.0.0.0 by default. To connect the
device to the PC, the network card must be configured as follows.
Set the required IP address in the network card menu. Select the TCP/IP protocol
in the network card properties and select the "Use the following IP address"
setting there. Enter the required IP address and subnet mask.
Note!
Device restart
You must restart the device after changing the Ethernet configuration.