Basic settings
Settings for use with a PBX are given in the section "Operation with a PBX".
To ensure that the displayed call charge is correct, the call charge factor must be set. When the
telephone leaves the factory the call charge factor is set to 12.1 1 (12.1 1 pfennig). The current
call charge factor can be obtained from your telecoms operator.
See also "Call charges per user; call charge total"
You can change the currency unit as necessary:
Press @ and then press Fl as often as necessary
until "INSTALLATION' is displayed. Confirm the
menu selection by pressing I33
Press m as often as necessary until "CHARGES" is
displayed. Confirm the menu selection by pressing
"FACTOR" is displayed. Confirm by pressing IOK
The current call charge factor setting is displayed
and confirm by pressing @IOK The entry is con-
firmed by a short signal tone.
Press @ then press i3l as often as necessary until
selection by pressing lKi.
Press 141 as often as necessary until "CHARGES" is
displayed. Confirm the menu selection by pressing
Press m as often as necessary until "CURRENCY'
is displayed. Confirm the menu selection by
pressing I.
"CURRENCY DM" is displayed. Enter the currency
abbreviation (max. 4 characters) and confirm by
pressing I.
total are displayedin the definedcurrency
12
Need help?
Do you have a question about the Eurit 22 and is the answer not in the manual?