Disposal; Manufacturer's Warranty - Dx Tools - Hilti DX860-ENP Operating Instructions Manual

10. Disposal

Most of the materials from which Hilti powder-actuated tools are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements
for taking back your old powder-actuated tools for recycling. Please ask your Hilti customer service department
or Hilti sales representative for further information. Should you wish to return the tool yourself to a disposal facility
for recycling, proceed as follows: Dismantle the tool as far as possible without the need for special tools. National
and international directives and regulations must be observed.
Separate the individual parts as follows:
Part/assembly
Toolbox
Outer casing
Piston
Piston stopper
Screws, small parts
Used/partly-used cartridge strips
11. Manufacturer's warranty – DX Tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid so
long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical sys-
tem is maintained. This means that only original Hilti
consumables, components and spare parts, or other
products of equivalent quality, may be used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement
as a result of normal wear and tear are not covered by
this warranty.
Additional claims are excluded, unless stringent
national rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inabil-
ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
Printed: 10.04.2017 | Doc-Nr: PUB / 5126862 / 000 / 01 Printed: 10.04.2017 | Doc-Nr: PUB / 5126862 / 000 / 00
Main material
Plastic
Plastic/synthetic rubber
Steel
Steel/plastic
Steel
Steel/plastic
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.
Confirmation of CIP testing
The Hilti DX 860-ENP has been system and type tested.
As a result, the tool bears the rectangular PTB approval
mark showing approval number S814. Hilti thus guar-
antees compliance with the approved type. Unaccept-
able defects or deficiencies, etc. determined during use
of the tool must be reported to the person responsible
at the approval authority (PTB) and to the Office of the
Permanent International Commission (C.I.P.).
Recycling
Plastics recycling
Plastics recycling
Scrap metal
Scrap metal
Scrap metal
In accordance with local regulations
en
11