[Network] Menu; [Wired Lan]; [Projector Name]; [Network Control] - Panasonic PT-VZ580 Operating Instructions (Functional Manual)

[NETWORK] menu

On the menu screen, select [NETWORK] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (

[WIRED LAN]

Perform the connection settings to use wired LAN.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f The [WIRED DETAILED SETUP] screen is displayed.
3) Press asqw to select an item, and change the setting according to the menu operation instructions.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]
[DNS2]
4) After the setting, select [OK] and press the <ENTER> button.
Note
f For the setting content of each item, consult your network administrator.
f When using the projector with [DHCP] set to [ON], confirm that the DHCP server is running.
r Factory default settings
f Following setting has been made as a factory default.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1] / [DNS2]

[PROJECTOR NAME]

You can change the projector name. Enter the host name if it is required to use a DHCP server.
1) Press as to select [PROJECTOR NAME].
2) Press the <ENTER> button.
f The [PROJECTOR NAME CHANGE] screen is displayed.
3) Select characters with the asqw buttons and press the <ENTER> button to enter the projector
name.
f You can enter up to eight characters.
4) After entering the projector name, press as to select [OK] and press the <ENTER> button.

[NETWORK CONTROL]

Set up the control method of the network.
1) Press as to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3) Press as to select an item and press qw to change the setting.
86 - ENGLISH
Chapter 4 Settings - [NETWORK] menu
Æ
page 50) for the operation of the menu screen.
[ON]
[OFF]
Enter the IP address when [DHCP] is set to [OFF].
Enter the subnet mask when [DHCP] is set to [OFF].
Enter the default gateway address when [DHCP] is set to [OFF].
Enter the preferred DNS server address when [DHCP] is set to [OFF].
Enter the alternate DNS server address when [DHCP] is set to [OFF].
[OFF]
192.168.10.100
255.255.255.0
192.168.10.1
(Blank)
Set when a DHCP server exists in the network to which the
projector is connected and the IP address is obtained automatically.
Set when a DHCP server does not exist in the network to which the
projector is connected and you need to specify the IP address.