When The Initial Setting Screen Is Displayed - Panasonic PT-VZ580 Operating Instructions (Functional Manual)

Note
f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] (
approximately ten seconds longer before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.
f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], it may take approximately one
minute to enable the network function after connecting the power cord to the outlet.

When the initial setting screen is displayed

When the projector is switched on for the first time after purchase or the [PROJECTOR SETUP] menu →
[INITIALIZE ALL] is executed, the [INITIAL SETTING] screen is displayed after the projection starts. Set them in
accordance with circumstances. In other occasions, you can change the settings by menu operations.
When the [INITIAL SETTING] screen is displayed, you can return to the previous screen by pressing the
<MENU> button.
Note
f When the projector is used for the first time, in order to clearly display the menu screen, it may be necessary to adjust the focus lever and the
zoom lever in the projection lens area of the projector (
Initial setting (display language)
Select the language to show on the screen.
After the initial setting, you can change the display language from the [LANGUAGE] menu.
1) Press asqw to select the display language.
2) Press the <ENTER> button to proceed to the following initial setting.
Initial setting (projector setup)
If necessary, change the setting of each item.
1) Press as to select an item.
Item
[PROJECTION METHOD]
[SCREEN FORMAT]
[SCREEN POSITION]
[STANDBY MODE]
2) Press qw to switch the setting.
f When all settings are completed, proceed to Step 3).
Chapter 3 Basic Operations - Switching on/off the projector
Æ
page 20). For details, refer to "How to adjust the state of the image" (
INITIAL SETTING
ENTER
SELECT
INITIAL SETTING
PROJECTION METHOD
SCREEN FORMAT
SCREEN POSITION
STANDBY MODE
Also, you cannot use some RS-232C
ENTER
SELECT
Set [PROJECTION METHOD] depending on the installation mode.
Set the aspect ratio of the image.
Set the display position of the image.
Set the operation mode during standby.
PLEASE SELECT LANGUAGE.
AUTO
4:3
NORMAL
If STANDBY MODE is set to ECO,
you cannot use network functions
when the projector is standing by.
protocol commands.
RETURN
Description
Æ
page 78) , it may take
Æ
page 42).
ENGLISH - 37