Switching On The Projector - Panasonic PT-VZ580 Operating Instructions (Functional Manual)

Indicator status
Off
Lit
Red
Blinking
*1
Lit
Blinking
*2
Green
Blinking
*3
Orange Lit
*1 The indicator flashes in the cycle: 2.75 seconds (light) → 0.25 seconds (off)
*2 The indicator flashes in the cycle: 2.0 seconds (light) → 2.0 seconds (off)
*3 The indicator flashes in the cycle: 0.5 seconds (light) → 0.5 seconds (off)
Note
f While the power indicator <ON (G)/STANDBY (R)> lights in orange, the fan is running to cool the projector.
f For about 90 seconds after the projector is switched off, the luminous lamp does not light up even if the power is switched on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks in red.
f The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lights/blinks in red). Refer to "Power
consumption" (x page 125) for the power consumption.

Switching on the projector

Before switching on the projector, make sure all the other devices are correctly connected (
lens cap is removed beforehand.
1) Connect the power cord to the projector.
2) Connect the power plug to an outlet.
f The power indicator <ON(G)/STANDBY(R)> lights/blinks, and the projector will enter the standby mode.
3) Press the power <v/b> button.
f The power indicator <ON(G)/STANDBY(R)> lights in green and the image is soon projected on the screen.
Attention
f Be sure to remove the lens cap before starting projection.
36 - ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector
The power plug is not connected to the outlet.
The power is switched off (in standby mode).
Projection will start when the power <v/b> button is pressed.
f The setting of the projector is as follows.
g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO].
f The projector may not operate when the lamp indicator <LAMP> or the temperature indicator <TEMP> is
blinking. (x page 107)
The power is switched off (in standby mode).
Projection will start when the power <v/b> button is pressed.
f The setting of the projector is as follows.
g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to
[NORMAL].
f The projector may not operate when the lamp indicator <LAMP> or the temperature indicator <TEMP> is
blinking. (x page 107)
Projecting.
The luminous lamp is turned off.
The luminous lamp lights when a signal is input or a button operation is performed.
f The setting of the projector is as follows.
g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [POWER MANAGEMENT] is set to
[READY].
The projector is preparing to project.
The projector will project image after a while.
The projector is preparing to be switched off.
The power will be switched off after a while. (Changes to the standby mode.)
2) 1)
Projector status
3)
Æ
page 31) and the
3)