Table of Contents
Advertisement
Front cage frame screws
Front cage frame screws
Figure 80. Replacing a midplane
10. Grab the blue handle in the center of the front cage frame and pull it outward
to slide the front cage frame out approximately two inches. Grab the two sides
of the front cage frame and remove it from the chassis.
11. Unpack the new front cage frame with the midplane. Save the packaging
materials in case you need to return it.
12. Insert the new midplane by aligning it with the storage subsystem front
opening and slowly sliding it into the storage subsystem chassis. Make sure
that the front cage frame EMC gaskets do not snag between the frame and
chassis.
13. Tighten the four front cage frame screws.
14. Insert the EV-DDM CRUs. Be sure you insert them in the correct slots. Use the
labels you put on them before you removed them to guide you.
15. Re-insert the controllers and reconnect the fibre channel cables.
16. Re-insert the power supply and fan units and reconnect the power supply
cords.
17. Power on the attached storage expansion enclosures.
18. Wait at least 3 minutes and then power on the DS4200 Express Storage
Subsystem. Verify the status of the configuration using LEDs and the DS4000
Storage Manager client program.
810midpl
Chapter 5. Replacing components
133
Advertisement
Table of Contents
