Table of Contents
Advertisement
Figure 16. Removing a EV-DDM CRU
5. Place the EV-DDM CRU horizontally on a level surface.
6. Repeat step 1 on page 35 through step 4 on page 35 for additional EV-DDM
Installing the DS4200 Express into a rack on the support rails
Complete the following steps to install the DS4200 Express in the rack cabinet.
CAUTION:
Do not install modules or other equipment in the top half of a rackmount
cabinet while the bottom half is empty. Doing so can cause the cabinet to
become top-heavy and tip over. Always install hardware in the lowest
available position in the cabinet.
Statement 4:
≥ 18 kg (39.7 lb)
CAUTION:
Use safe practices when lifting.
1. Put on antistatic protection, and keep it on while performing all of the remaining
36
IBM System Storage DS4200 Express Storage Subsystem: Installation, User's and Maintenance Guide
Attention:
Do not stack EV-DDM CRUs on top of one another. Protect the
EV-DDM CRUs from vibrations or sudden shocks.
CRUs.
procedures in this chapter.
≥ 32 kg (70.5 lb)
≥ 55 kg (121.2 lb)
Advertisement
Table of Contents
