Table of Contents
Advertisement
Attach fiber-optic interface cables to each host adapter. You will connect the other
end of the cables to the controller later in the installation process. For more
information about handling fiber-optic cables, see "Handling fiber-optic cables" on
page 44.
Cabling the power supply
Complete the following steps to connect the power supply cable:
1. Using the supplied strap, tie the power supply cord to the rail to provide strain
2. Attach the power supply nut and tighten it securely.
3. Connect the power cable to the power supply.
4. Plug the supply power cable into a properly grounded electrical outlet. For
5. Continue with "Powering on the storage subsystem" on page 81 for the initial
78
IBM System Storage DS4200 Express Storage Subsystem: Installation, User's and Maintenance Guide
relief for the power cord.
maximum protection against power loss, connect each of the two power
supplies to a different power source.
startup of the storage subsystem.
Advertisement
Table of Contents
