A4.8 Motor Adjustment - Electrolux WTCS90ERB Service Manual

Electrolux
EFS - Dishwashing Systems Platform
Electrolux Professional
Wait about 5 seconds, until the display will show:
If the pressure sensor setting procedure is sterted without having previously emptied the tanks and air gap,
the following message appears:
EMPTY BOTH TANKS AND AIRGAP
BEFORE MAKING SENSORS SET-UP
A4.8 MOTOR ADJUSTMENT
Press the "confirm" button "C" (Figure 1) when the selection arrow indicates the item "MOTOR ADJUST"
(Modular RT's) or when the item
ting procedure is accessed.
WARNING:
The procedure is carried out after the installation of possible external tables and without placing
racks in the machine.
In fact, the machine has an algorithm that controls the current absorbed by the feed gear motor and blocks the
rack feed in case of mechanical jamming of racks or dishes. For the control of current to be carried out in the
best of ways, setting of the gear motor current must carried out.
Gear motor setting cannot be carried out if an error in communication between the cards of the Rack Type is
in progress. In this case the display shows:
GEARMOTOR
NOT AVAILABLE
PRESS
If the communication functions properly, the display shows the screen indicating that the machine is ready to
carry out gear motor current setting.
PRESS
Press the confirm button "C" (Figure 1) to start the setting cycle.
DOC. NO. 5956.573.05
PRES. SENS. SET-UP
DONE.
PRESS TO EXIT
PRES. SENS. SET-UP
NOT EXECUTED
PRESS TO EXIT

(compact RT's) appears on the display, and the gear motor current set-
GEARMOTOR SET-UP
SET-UP
TO EXIT
GEARMOTOR SET-UP
TO START
OR TO EXIT
snS
AdJ
End
snS
AdJ
n_d
mot
AdJ
n A
mot
AdJ
rdy
P. 37 / 88