Manual Adjustment; Electronic Adjustment - Electrolux AEG FAVORIT 35020 VI User Manual

32
Setting the water softener
°dH
< 4
1) No use of salt required.
You must set the water softener manually and electronically.

Manual adjustment

The appliance is set at the factory at position 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position 1
or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.

Electronic adjustment

The water softener is set at the factory at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme selection/cancel button.
4. Release the programme selection/cancel button when programme indicator light A
starts to flash and programme indicator light B comes on.
5. Wait until programme indicator light B goes off.
– Programme indicator light A starts to flash.
– The end-of-programme indicator light starts to flash.
6. Press the programme selection/cancel button one time.
– Programme indicator light A starts to flash.
– The setting function of the water softener is activated.
– The end-of-programme indicator light flashes to show the level of the water soft-
ener.
Example: 5 flashes, pause, 5 flashes, pause, etc. = level 5.
7. Press the programme selection/cancel button one time to increase the water softener
level by one step.
8. Press the on/off button to save the operation.
Water hardness
°TH mmol/l
< 7 < 0,7
Water hardness setting
Clarke manually
< 5
1)
1
electronically
1)
1