Local Router Setup - Technicolor TG789vac v2 Setup And User Manual

Modem router

Hide thumbs Also See for TG789vac v2:

Table of Contents

2.1.2 Local router setup

Procedure

Proceed as follows:

1 Take an Ethernet cable. If your package contains an Ethernet cable with red connectors, you must use that cable.

If you use another Ethernet cable than the one included in your package, make sure that the Ethernet cable is a

fully wired CAT5E or CAT6 Ethernet cable.

2 Plug one end of the cable in the

3 Plug the other end of the cable into the Ethernet port of your Internet access device (for example, an Optical Network

Terminal (ONT) for Fiber).

The WAN port can only be used to connect your TG789vac v2 to an Internet access device. You cannot use it to

connect other devices (for example, a computer) to the TG789vac v2.

This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and

communication of its contents, is not permitted without written authorization from Technicolor.

red

WAN port on the back of your TG789vac v2.

2 Setting up your TG789vac v2

WAN

Table of Contents