Product Features; Assembly Instructions - Central Machinery 61750 Owner's Manual & Safety Instructions

Combination sander 6 inch belt & 9 inch dick

Hide thumbs

Table Of Contents

Table of Contents

NOTE: Prior to assembling and operating the Belt/Disc Sander, it is important to

familiarize yourself with all of the machine's major components. Failure to do so

may result in personal injury and/or damage to the machine and workpiece being

sanded. (See Figure B, and refer to the "Operating Instructions" section in

this manual.)

9" SANDING DISC

(32)

FIGURE B

NOTE: For additional references to the parts listed below, refer to the Assembly

Diagram on page 17.

To Assemble the Stands, Frames, and Upper Bracket:

With assistance, position the two Side Stand Supports (76) upright on the floor

and parallel to one another. (See Figure C.)

Place the end of one Frame (85) on the inside edge of one Side Stand Support

(76), and align the two mounting holes on the end of the Frame with the two

lower mounting holes on the Side Stand Support. (See Figure C.)

Secure the Frame (85) to the Side Stand Support (76), using two Bolts (77), two

Washers (83), and two Nuts (84). (See Figure C.)

Repeat Steps #1, #2, and #3 to connect the other end of the Frame to the

remaining Stand. (See Figure C.)

For technical questions, please call 1-888-866-5797.

Item 61750