Central Machinery 61750 Owner's Manual & Safety Instructions page 14

To Adjust the Sand Belt Frame for Vertical Sanding:
Loosen the two Nuts (5) on the Sanding Belt Frame (106), and with assistance
raise the Sanding Belt Frame to its full vertical position. Then, firmly retighten the
two Nuts to lock the Sanding Belt Frame in place. (See Figure L.)
FIGURE L
To Adjust the Position of the Table:
1. When the Sanding Belt Frame (106) is in its vertical position, the Work
Table (41) should be repositioned to the front of the Sanding Belt Frame. (See
Figure M, next page.)
2. To reposition the Work Table (41), loosen the two Screws (53) and remove the
Work Table, including the Support Bar (56). (See Figure M.)
3. Insert the Support Bar into the Mounting Hole, and tighten the other two Set
Screws (67 & 50). (See Figure M.)
4. NOTE: When repositioning the Work Table (41), make sure there is more
than / " clearance but less than
1
16
Sanding Belt Frame (106). (See Figure M.)
For technical questions, please call 1-888-866-5797.
Item 61750
NUT (5) SANDING BELT FRAME (106)
(VERTICAL POSITION)
/ " clearance between the Table and the
1
8
Page 14