Central Machinery 61750 Owner's Manual & Safety Instructions page 16

To Perform Horizontal Sanding with the Sanding Disc:
CAUTION: Before each use, inspect the condition of the Sanding Disc (32).
1.
Look for tearing, excessive wear, or other damage to the Sanding Disc. Never
use a Sanding Disc that is damaged. When replacing, never use an inexpensive,
low quality Sanding Disc.
2. NOTE: The Sanding Disc (32) is typically used for smaller workpieces.
3. Plug the Power Cord (59) into a grounded, 110 Volt electrical outlet. (See
Figure B.)
4. Turn the Power Switch (64) to its "ON" position, and allow the Sanding Disc (32)
to come to full speed for approximately ten seconds before feeding the
workpiece into the Sanding Disc. (See Figure B.)
Hold the workpiece firmly with both hands, and carefully set it flat and level upon
5.
the Work Table (41). (See Figure B.)
6. Apply moderate inward pressure on the workpiece, allowing the Sanding
Disc (32) to cut without being forced.
7. Once the sanding procedure is completed, remove the workpiece from the
Sanding Disc (32), turn the Power Switch (64) to its "OFF" position, and unplug
the Power Cord (59) from its electrical outlet. (See Figure B.)
To Perform Vertical Sanding with the Sanding Belt:
1. Adjust the Sanding Belt Frame (106) and Work Table (41) for a vertical sanding
procedure. (See Figures L, and M.)
Plug the Power Cord (59) into a grounded, 110 Volt electrical outlet. (See
2.
Figure B.)
3. Turn the Power Switch (64) to its "ON" position, and allow the Sanding Belt (1) to
come to full speed for approximately ten seconds before feeding the workpiece
into the Sanding Belt. (See Figure M.)
4. Hold the workpiece firmly with both hands, and carefully set it flat and level upon
the Work Table (41). (See Figure M.)
5. Apply moderate inward pressure on the workpiece, allowing the Sanding Belt (1)
to cut without being forced. (See Figure M.)
6. Once the sanding procedure is completed, remove the workpiece from the
Sanding Belt (1), turn the Power Switch (64) to its "OFF" position, and unplug the
Power Cord (59) from its electrical outlet. (See Figure B.)
For technical questions, please call 1-888-866-5797.
Item 61750
REV 14d
Page 16