Inspection, Maintenance, And Cleaning; Please Read The Following Carefully - Central Machinery 61750 Owner's Manual & Safety Instructions

INSPECTION, MAINTENANCE, AND CLEANING

1. CAUTION: Always turn the Power Switch (64) to its "OFF" position and
unplug the Power Cord (59) from its 110 volt electrical outlet before
performing any inspection, adjustments, maintenance, or cleaning.
BEFORE EACH USE, inspect the general condition of the Belt/Disc Sander.
2.
Check for loose screws, misalignment or binding of moving parts, cracked or
broken parts, damaged electrical wiring, excessively loose Sanding Belt (1) and
Sanding Disc (32), and any other condition that may affect its safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further
use. Do not use damaged equipment.
DAILY: Sanding Belts (1) and Sanding Discs (32) must be sharp and clean to
3.
perform properly. Depending on materials sanded and frequency of tool use,
Sanding Belts and Sanding Discs become clogged with wood particles and dull.
Dull Sanding Belts and Sanding Discs rub the workpiece rather than cut, which
results in increased friction, higher temperatures, and a burned workpiece. As
often as possible, check the condition of the Sanding Belt and Sanding Disc and,
if necessary, replace a worn Sanding Belt and Sanding Disc with a new, 6" wide
by 48" Sanding Belt and 9" diameter Sanding Disc.
4. DAILY: With a soft brush, cloth, or vacuum, remove all sawdust and debrisfrom
the Belt/Disc Sander. Then, use a premium quality, lightweight machine oil to
lubricate all moving parts.

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND
ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE
MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY
OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS
TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS THERETO.
For technical questions, please call 1-888-866-5797.
Item 61750 Page 17