Sharp VL-Z400H-T Service Manual page 5

4.
x
Camera top cover
Camera unit
b
a
FPC(1)
· Remove the screw ((x) LX-HZ0050TAFN), screw ((p) LX-
HZ0063TAFN) and screw ((a) XiPSN17P02000), remove the
camera top cover.
· Remove the screw ((b) XiPSN17P03000) from the camera
unit, disconnect the FPC (1), (2) and remove the camera unit.
· Remove the screw ((b) XiPSN17P03000), disconnect the
FPC (3) and remove the VF.
5.
Sub PWB unit
Heat release angle
b
b
Connector
· Disconnect the two connectors of the sub PWB unit and main
PWB unit.
· Remove the two screws ((b) XiPSN17P03000) from the heat
release angle, remove the screw ((b) XiPSN17P03000) from
the PWB unit and remove each unit.
· Disconnect the two FFCs of the main PWB unit.
· Remove the two screws ((x) LX-HZ0050TAFN), remove the
screw ((x) LX-HZ0050TAFN) form the PWB mounting angle
and remove the terminal cabinet.
b
VF
p
FPC(2)
FPC(3)
x
b
Terminal cabinet
Main PWB unit
x
PWB mounting angle
x
Tilt FPC
6.
u u
· Remove the screw ((b) XiPSN17P03000) and remove the
Mechanism reversion detection PWB unit.
· Remove the three screws ((u) LX-BZ0221TAFC) and remove
the PWB mounting angle.
7.
LCD tilt unit assembly
b
a
b
· Turn the LCD tilt unit assembly 90 degrees.
· Remove the three screws ((b) XiPSN17P03000).
· Remove the screw ((a) XiPSN17P02000).
5
VL-Z400S-T/H-T
VL-Z500S-S/H-S/E-T/E-S
b
Mechanism reversion detection PWB unit
u
PWB mounting angle
b