Phase-Adjust - Sharp VL-Z400H-T Service Manual

VL-Z400S-T/H-T
VL-Z500S-S/H-S/E-T/E-S

8-4. Phase-adjust

Phase-adjust the following parts.
(1) Mode SW
(2) Main cam
(3) Sub cam (The main cam and sub cam should be also phase-adjusted for the chassis.)
(4) S loading arm
(5) Tu loading arm
(6) Loading drive gear (main cam, sub cam, S loading gear)
Note) Check the marker position carefully before disassembling.
Note) When installing the loading drive gear, check that the main cam, sub cam, S loading gear are all phase-adjusted.
(1)Mode SW
Phase adjustment
mark
Phase adjustment
(gear section)
Phase adjustment
hole (for chassis)
(4)S Loading arm ass'y
(2)Main cam
Fig.1
Phase adjustment
mark
(4)S loading arm ass'y
Fig.2
(5)Tu loading arm ass'y
Phase adjustment
mark
Phase adjustment hole
(for chassis)
(6)Loading gear drive gear
(5)Tu loading arm ass'y
18
Phase adjustment
hole (for chassis)
(3)Sub cam