Removable Hard Disk Installation - Datavideo TVS-1000 Instruction Manual

2.3

Removable Hard Disk Installation

How to Assemble 2.5" HDD in Removable Rack
Warning: You must use TVS-1000 proprietary HDD and not any Datavideo HDR series or DN
series.
Avoid HOT PLUGGING during operation (while writing to and reading from the disk) because it
may cause damage to the system and files.
1. Remove the two screws on the rear cover of
the removable 2.5" HDD enclosure and
manually pull out the PCB.
2. Tighten four screws to fasten 2.5" HDD on
the PCB as shown in the diagram below.
3. Push the PCB with 2.5" HDD into the HDD
enclosure.
4. Tighten the two screws of the rear cover of
the removable 2.5" HDD enclosure.
5. Push the removable 2.5" HDD enclosure into
the front slot of TVS-1000 system.
9