Chain Alignment - Technogym Bikerace Service Maintenance Manual

BIKERACE: Service & Maintenance Manual - rev. 1.1

8.3. CHAIN ALIGNMENT

Machine version with non threaded pin:
Figure 8.3-1
Figure 8.3-2
Carry out the procedures described in paragraph
7.6. "Disassembling the right and left side
guards".
1. From both sides of the machine, use a marker
pen to fix a reference point between cam a
and the frame.
Working from the left-hand side:
2. Unscrew the 2 screws b which clamp cam a
to the frame using a 4-mm hex T wrench.
3. Remove snap ring c using the special pliers.
4. Remove the cam.
5. Use a pointed tool to push pin d inward until
the spacers come out, being careful to
recover the Teflon spacer and the washers if
present.
6. Move the spacers from one side to the other
to align the chain.
7. After completing the adjustment, lock down
what previously backed off.
To ensure correct alignment of the
chain, move it back and forth and make
sure that there is no noise.
After completing this procedure, check
the chain tension as described in
paragraph 8.4. .
Page 8.3