BIKERACE: Service & Maintenance Manual - rev. 1.1
9. CONFIGURING THE MACHINE
9.1. MACHINE HW CONFIGURATION
The HW configuration of the machine is set using the 2 banks of dip-switches on the back of the
CPU board, according to the tables below:
9.1.1.
M
ACHINE
Using the bank of 4 dip-switches on the back of the CPU board, it is possible to set the machine
number as illustrated below:
To be enabled for printing, the machine must be configured with all dip-switches in ON
position.
9.1.2.
A
LTERNATOR CONFIGURATION
This procedure is applicable starting from SW version 6.0 .
Using the 2 dip-switches of the 2-switch bank on the back of the CPU board, it is possible to set the
type of alternator that is fitted on the machine, as indicated below:
N
.
O
CONFIGURATION
Right hand bank
Dip-switch
1
2
3
ON
OFF
OFF
OFF
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
Left-hand bank
Dip-switch
1
2
OFF
OFF
ON
ON
ON
OFF
OFF
ON
Number
4
ON
1 – MASTER
OFF
2
OFF
3
OFF
4
OFF
5
Alternator
OLD EFEL
NEW EFEL
REAL
MAGNETI MARELLI
Page 9.1