Connecting To The Printer - Technogym Bikerace Service Maintenance Manual

4.2. CONNECTING TO THE PRINTER

The machine is pre-set for printing via the full duplex RS 485 port available on the serial ports
panel.
If the machine is equipped with Technogym System SW, the print function is not
available.
The printer is connected using a special cable, which can be ordered using code A419. This cable is
equipped with an RS 485 to RS 232 serial converter. The printer connection diagram is as follows:
WARNING: In order to enable the print function, the 4 dip-switches of the right-hand
group must be set as indicated in paragraph 9.1. .
The printer used must conform to the following specifications:
• equipped with RS 232 serial port;
• 80 characters;
• 8 data bits;
• 1 stop bit;
• 9600 baud;
• no parity;
• ASCII characters.
Page 4.2
BIKERACE: Service & Maintenance Manual - rev. 1.1