The Machine Does Not Print - Technogym Bikerace Service Maintenance Manual

6.5. THE MACHINE DOES NOT PRINT

This error occurs when there are HW problems, or if the machine has not been configured correctly.
Always check that the printer itself is working correctly first.
Replace or rewire the printer
cable
Follow the step by step procedure to correctly diagnose the problem. Take particular care with the
checks highlighted by circled numbers, which are described in detail below:
(1) Open the display and configure the 4 dip-switches as indicated in the paragraph 9.1. "Machine
HW configuration".
(2) This check is carried out using the RS 232 tester.
Page 6.10
THE MACHINE
DOES NOT
PRINT
Is the machine correctly configured for
printing?
Does the signal reach the output of
the printer cable correctly?
NO
Is the printer cable OK?
BIKERACE: Service & Maintenance Manual - rev. 1.1
1
NO
YES
2
YES
NO
3
YES
Correctly configure the
machine
There is a problem with the
printer or the PC serial port
or their respective
configurations
Replace the CPU board