Disassembling The Pulley - Technogym Bikerace Service Maintenance Manual

7.11. DISASSEMBLING THE PULLEY

Figure 7.11-1
Page 7.14
BIKERACE: Service & Maintenance Manual - rev. 1.1
Carry out the procedures described in paragraphs
7.6. "Disassembling the right and left side
guards", 7.9. "Disassembling the belt " and 7.10.
"Disassembling the chain".
Regardless of the type of pin:
1. Push pin a until it comes out from the free
side.
2. Remove the PULLEY from the side.
After completing the procedure, adjust
the alignment and tension of the chain
and belt as described in paragraphs 8.1.
, 8.2. , 8.3. and 8.4. .
To reassemble the PULLEY, carry out the above
steps in reverse order.