Harman Kardon HKTS 10 Service Manual page 7

HKTS 10
SPEAKER CONNECTIONS (continued)
Dolby Pro Logic
(Non-Digital) – Line Level
USE THIS INSTALLATION METHOD FOR
DOLBY PRO LOGIC APPLICATIONS (NOT
DOLBY DIGITAL, DTS OR OTHER DIGITAL
PROCESSING), WHERE THE RECEIVER/
PROCESSOR IS EQUIPPED WITH A SUB-
WOOFER OUTPUT, OR A VOLUME-
CONTROLLED PREAMP (LINE-) LEVEL
OUTPUT:
Use the supplied RCA-type patch cord to
connect the line-level subwoofer output on
your receiver or amplifier to either the left or
right Line-Level Full-Range Input ¢ on
the SUB-TS10 subwoofer. Use both the left
and right inputs on the subwoofer if your
receiver or processor has both left and right
line-level outputs.
If your receiver is equipped with line-level
outputs but does not have a separate sub-
woofer output, use a Y-adaptor (not supplied)
to bridge the receiver's preamp output to the
main amp input for that channel, and connect
the long end of the adaptor to the corre-
sponding line-level input on the SUB-TS10.
IMPORTANT: Do not use the SUB Input £
on the subwoofer with Dolby Pro Logic
processors. Make sure that you have config-
ured your surround sound processor for
"Subwoofer On. " The front left, front right,
center and rear surround speakers should
all be set to "Small. "
When all connections have been made, plug
the AC power cord on the subwoofer into
an AC outlet.
Connect each speaker to the corresponding
speaker terminals on your receiver or amplifier.
Front
Left
– +
Front
Left
Surround
Left
Surround
Left
– +
harman/kardon
Center
– +
SUB-TS10
Subwoofer
Line-Level
L
R
Front
Right
SUB/LFE
Out
Surround
Center
Right
Receiver
Front
Right
– +
Surround
Right
– +
6