Related Manuals for Harman Kardon HKTS 11
Summary of Contents for Harman Kardon HKTS 11
- Page 1 ® Power for the Digital Revolution ® HKTS 11 HOME THEATER SPEAKER SYSTEM OWNER’S MANUAL...
-
Page 2: Table Of Contents
Please register your product on our Web site at www.harmankardon.com. Note: You’ll need the serial number of your new home theater speaker system. At the same time, you can choose to be notified about our new products and/or special promotions. -
Page 3: Safety Information
Read First! Important Safety Precautions! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. -
Page 4: Introduction
INTRODUCTION Introduction Thank you for purchasing the Harman Kardon HKTS 11, with which you’re about to begin many years of listening enjoyment. The HKTS 11 has been custom-designed to provide all the excitement and power of the cinema experience in your own living room. -
Page 5: Sub-Ts11 Subwoofer Amplifier Panel Controls And Connections
SUB-TS11 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS SUBWOOFER LEVEL ¡ FILTER ™ £ ¢ PHASE REVERSE ∞ NORMAL § LINE LEVEL ¶ • ª ‚ IMPORTANT: CONNECT STRIPED WIRE TO RED ( ) SPEAKER TERMINAL. ⁄ ¡ Subwoofer-Level Control ™ High-Cut (Low-Pass) Filter Switch £... - Page 6 SUB-TS11 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS place itself in the Standby mode, depending on whether it is receiving an audio signal. When this switch is placed in the ON position, the SUB-TS11 will remain on, whether or not it is receiving an audio signal.
-
Page 7: Speaker Placement
Color-Coding System The HKTS 11 uses the channel color-cod- ing system established by the Consumer Electronics Association to make setting up your home theater speaker system as easy as possible. Your system includes a set of colored stickers that may be placed near... -
Page 8: Mounting Options
MOUNTING OPTIONS Satellites and Surrounds Wall Plate Wall-Mounting 15mm or 1/2" Unscrew the bolt that attaches the black shelf stand to the bottom of the speaker. Store the stand and bolt in a safe place, in case they are needed for a future installation. -
Page 9: Speaker Connections
CEA standard and therefore use a color other than red or black for the (+) ter- minal to indicate some speaker positions: e.g., surround left. Although the HKTS 11 system has red and black collars on the individual speaker terminals to denote the... -
Page 10: Dolby Digital Or Dts (Or Other Digital Surround Mode) Connection
SPEAKER CONNECTIONS Dolby ® Digital or DTS ® (or Other Digital Surround Mode) Connection USE THIS INSTALLATION METHOD FOR DOLBY DIGITAL, DTS OR OTHER DIGITAL SURROUND PROCESSORS: Use the line-level input jack marked SUB § for the low-frequency effects channel. Connect this jack to the subwoofer output or LFE output on your receiver or amplifier. -
Page 11: Dolby Pro Logic (Non-Digital) - Line Level
Dolby Pro Logic ® (Non-Digital) – Line Level USE THIS INSTALLATION METHOD FOR DOLBY PRO LOGIC APPLICATIONS (NOT DOLBY DIGITAL, DTS OR OTHER DIGITAL PROCESSING), WHERE THE RECEIVER/ PROCESSOR IS EQUIPPED WITH A SUBWOOFER OUTPUT, OR A VOLUME- CONTROLLED PREAMP (LINE-) LEVEL OUTPUT: Use the supplied RCA-type interconnect cable to connect the line-level subwoofer... -
Page 12: Dolby Pro Logic (Non-Digital) - Speaker Level
SPEAKER CONNECTIONS Dolby Pro Logic (Non-Digital) – Speaker Level USE THIS INSTALLATION METHOD FOR DOLBY PRO LOGIC APPLICATIONS (NOT DOLBY DIGITAL, DTS OR OTHER DIGITAL PROCESSING), WHERE THE RECEIVER/ PROCESSOR DOES NOT HAVE A SUB- WOOFER OUTPUT, OR A VOLUME- CONTROLLED PREAMP (LINE-) LEVEL OUTPUT: Connect your receiver or amplifier’s front... -
Page 13: Operation
Move the Master Power Switch ‚ (marked Power) to the “ • ” (On) position. The SUB-TS11 subwoofer will automatically turn itself on or go into Standby mode, depending on whether or not a signal is being sent to it by your receiver or surround processor, and provided that the Audio- Sense On/Off Switch ¢... -
Page 14: Troubleshooting
TROUBLESHOOTING SYMPTOM SOLUTION If there is no sound from • Check that receiver/amplifier is on and a source is playing. • Check that the powered subwoofer is plugged in and its Master Power Switch ‚ is switched on to the “ • ” position. any of the speakers: •... -
Page 15: Specifications
2.2 lb (1kg) All features and specifications are subject to change without notice. Harman Kardon and Harman International are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries. Dolby and Pro Logic are registered trademarks of Dolby Laboratories. - Page 16 250 Crossways Park Drive, Woodbury, New York 11797 516.255.HKHK (4545) Fax: 516.682.3523 ® © 2006 Harman International Industries, Incorporated. All rights reserved. ® Part No. 406-000-05466-E Printed 8/06...