EN 61000-3-2:2000 EN 61000-3-3:1995+A1:2001 EN 60065:2002 Carsten Olesen Harman Kardon Europe 12/03 Typographical Conventions In order to help you use this manual, certain conventions have been used. Example – (bold type) indicates a specific control or rear-panel connection on the SUB-TS7 sub- woofer –...
Introduction Introduction The HKTS 7 subwoofer is easy to connect to your Included system, since it’s equipped with a special sub- Thank you for purchasing the Harman Kardon woofer input for use with equipment that has a HKTS 7, with which you’re about to begin many dedicated subwoofer connection that carries a years of listening enjoyment.
Rear Panel Connections SUBWOOFER LEVEL SUB-TS7 For use with HKTS 7 System ¡ FILTER ™ CAUTION CAUTION £ RISK OF ELECTR IC SHOCK RISK OF ELECTR IC SHOCK RISK OF ELECTR IC SHOCK DO NOT OPE N DO NOT OPE N...
Page 5
Rear Panel Connections Line-Level Subwoofer (SUB) Input: Con- Master Power Switch: Place this switch in nect the subwoofer output of a receiver with the “•” position to power-on the SUB-TS7 sub- digital surround sound decoding, such as Dolby* woofer. The SUB-TS7 will then be either in the Digital or DTS ®...
Speaker Placement Color-Coding System Center Channel Speaker Surround Speakers The HKTS 7 uses the channel color-coding system established by the Consumer Electronics Green White Association to make setting up your home theater speaker system as easy as possible. Your 0-0,55 m...
Mounting Options Wall-Mounting The wall-mounted speaker may be pivoted from Wires to Speaker side to side; however, the bracket is not Unscrew the bolt that attaches the black shelf designed to tilt up or down, and attempting to stand to the bottom of the speaker. Store the tilt it will damage the bracket and possibly the stand and bolt in a safe place in case they are wall, which would not be covered by your war-...
CEA standard and therefore use a color other than red or black for the (+) terminal to indicate some speaker positions: e.g., surround left. Although the HKTS 7 system has red and black collars on the individual speaker terminals to denote the positive and negative connections,...
Speaker Connections Dolby Digital or DTS ® jack to the LFE output or subwoofer output Make sure that you have configured your sur- (or Other Digital Surround Mode) on your receiver or amplifier. Connect each round-sound processor for “Subwoofer On.” Connection speaker to the corresponding speaker terminals The front left, front right, center and rear speak-...
Speaker Connections Dolby Pro Logic (Non-Digital) – Use both the left and right inputs on the sub- If your receiver/processor has a built-in low- Line Level woofer if your receiver or processor has both left pass-crossover filter for the subwoofer output, and right line-level outputs.
Speaker Connections Dolby* Pro Logic* (Non-Digital) – Connect your receiver or amplifier’s front left Connect your receiver or amplifier’s center, left Speaker Level and right speaker terminals to the left and right and right surround-speaker terminals to the terminals on the subwoofer that are marked corresponding terminals on the back of your Use this installation method for Dolby Pro Logic “High Level In.”...
Operation Move the Master Power switch (marked Volume Additional Bass Adjustments “Power” ) to the “•” (On) position to use the Volume can be adjusted using the Subwoofer In addition to the volume adjustments described subwoofer. The SUB-TS7 subwoofer will auto- Level Control (above), as shown below.
Troubleshooting If there is no sound from • Check that receiver/amplifier is on and a source is playing. any of the speakers: • Check that the powered subwoofer is plugged in, its Power switch is switched on to the “ON•” position. •...
Weight 0.6kg All features and specifications are subject to change without notice. Harman Kardon and Power for the Digital Revolution are registered trademarks of Harman International Industries, Incorporated. * Trademarks of Dolby Laboratories. DTS is a registered trademark of Digital Theater Systems, Inc.
Need help?
Do you have a question about the HKTS 7 and is the answer not in the manual?
Questions and answers