Harman Kardon HKTS 10 Service Manual page 6

HKTS 10
SPEAKER CONNECTIONS (continued)
Dolby Digital or DTS (or other
Digital Surround Mode)
Connection
USE THIS INSTALLATION METHOD FOR
DOLBY DIGITAL, DTS OR OTHER DIGITAL
SURROUND PROCESSORS:
Use the line-level input jack marked SUB
£ for the Low-Frequency Effects channel.
Connect this jack to the subwoofer output
or LFE output on your receiver or amplifier.
Connect each speaker to the corresponding
speaker terminals on your receiver or
amplifier.
Make sure that you have configured your
surround sound processor for "Subwoofer
On. " The front left, front right, center and
rear surround speakers should all be set to
"Small. "
When all connections have been made, plug
the AC power cord on the subwoofer into
an AC outlet.
5
Front
Left
– +
Front
Left
Surround
Left
Surround
Left
– +
harman/kardon
Center
– +
SUB
LINE
LEVEL
R
IN
L
Front
Right
SUB/LFE
Out
Surround
Center
Right
Receiver
Front
Right
– +
Surround
Right
– +