Alarm; Night Mode; Call Block - Panasonic KX-TGD390C Operating Instructions Manual

Programming
*2 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select "Caller ID auto". To turn this feature off, select
"Manual". (Caller ID subscribers only)
To use this feature, set the date and time first (page 10).
*3 The preset melodies in this product ("Tone 3" - "Tone 5", "Melody 1" - "Melody 10")
are used with permission of © 2012 Copyrights Vision Inc.
*4 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to "A" if telephone line condition is not good.

Alarm

An alarm sounds at the set time for 3 minutes
once or daily. Alarm can be set for each
handset.
1
MMENUN#720
2
MbN: Select the desired alarm option. a
MSELECTN
3
Enter the desired month and date. a
MOKN
4
Set the desired time.
5
*: Select "AM" or "PM". a MOKN
6
MbN: Select the desired alarm tone. a
MSELECTN
7
MSELECTN a MOFFN

Night mode

Night mode allows you to select a period of
time during which the handset will not ring for
outside calls. This feature is useful for time
periods when you do not want to be disturbed,
for example, while sleeping. Night mode can
be set for each unit.
Important:
R If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
1
MMENUN#238
For assistance, visit www.panasonic.ca/english/support
20
TGD39xC_(en)_ver021.pdf 20
2
MbN: Select the desired setting. a
MSAVEN
3
Follow the directions on the display to
complete the operation.
Changing the start and end time
1
MMENUN#237
2
Follow the directions on the display to
complete the operation.

Call block

This feature allows the unit to block calls when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted ("Storing unwanted callers",
page 21).
– the unit receives a call without phone
number ("Blocking incoming calls that have
no phone number", page 21).
When a call is received, the unit rings once
while caller information is being received. If
the caller's phone number matches an entry in
the call block list, the unit emits no sound to
the caller, and disconnects the call. (Caller ID
subscribers only)
*1 This is called first ring. If you do not want
the first ring to sound, turn this setting to
"Off" (page 21).
Important:
R Blocked calls are logged in the caller list.
2016/01/25 15:56:51
*1