Maintenance - Vacmaster VJE1650SW Manual

5. Plug the power cord in to the power outlet. (fig. 5)
6. Turn the motor on by flipping the switch to the "I" position. (fig. 6)
7. Once you have finished vacuuming, flip the switch to the "O" position and
unplug the power cord from the power outlet.
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
DO NOT USE DUST BAG FOR LIQUID VACUUMING.
DON NOT USE THE PRE-FILTER FOR LIQUID VACUUMING.
O = OFF I = ON
W
ET VACUUM OPERATION
7 Vacuuming Liquids.
1 2
6
WARNING:
Before starting ensure to read, understand, and apply the safety
instructions in section 1. Reminder: do not vacuum hazardous substances.
1. Ensure that the power cord is disconnected from the power outlet. Ensure
that the tank is clean and free of dust and dirt. (fig. 1)
2. Remove the cartridge filter and install a foam filter over the filter basket
and place the top section back on the tank. (fig. 2)
3. Fit the desired nozzle to the vacuum hose. (fig. 3)
3 4 5
4. Ensure that the switch is in the "O" position before plugging the power
cord into the power outlet. (fig. 4)
5. Switch the Wet/Dry Vacuum on. (fig. 5)
6. After use, flip the switch to the "O" position and unplug the power cord,
then empty and dry the tank. (fig. 6)
When vacuuming large quantities of liquid from a sink or tank etc., do not
immerse the nozzle completely into the liquid; leave a gap at the top of the
nozzle opening to allow for air inflow. The machine is fitted with a float valve
that stops the suction when the tank reaches its maximum capacity. An
increase in motor speed will be noticed. When this occurs, turn off the
machine, disconnect from the power supply, remove the head from the tank
and empty the liquid into a suitable receptacle or drain. To continue
vacuuming, refit the head and proceed. After wet vacuuming, turn the
machine off and remove the plug from the power supply. Empty the tank and
clean and dry the inside and the outside before storage.
REMEMBER!
The foam filter must be removed after wet vacuuming, and a cartridge filter
must be installed before dry vacuuming again.
M
AINTENANCE
1 2 3
6
4 5