Page 2
Cartridge Filter Troubleshooting Thank you for purchasing this Vacmaster® vacuum cleaner. With Vacmaster® you are obtaining a high quality product that is engineered for optimal performance. This vacuum cleaner is capable of picking up dry materials as well as liquids.
ARRANTY • Use insulating gloves, an earth connector connected to the steel container, or Vacmaster® takes pride in producing a high quality, durable product. This any other protective equipment when using the vacuum cleaner in some special Vacmaster® product carries a limited two (2) year warranty against defects places such as carpet or insulated floor.
Page 4
• When using for hazardous dust extraction or collection tasks, use only certified Vacmaster HEPA filters. NPACKING AND CHECKING CARTON CONTENTS • Even when used with a HEPA filter, extremely small particles may pass through the filter, always wear appropriate protective safety equipment.
Page 5
ENERAL ASSEMBLY INSTRUCTIONS A Philips head screw driver is required. WARNING: DO NOT PLUG IN POWER CORD TO POWER SOCKET, MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET AND DRY VACUUM CLEANER. This HEPA vacuum cleaner is supplied with a certified HEPA filter that has been lot tested by an independent lab to IEST-RP-CC001 to show that it meets the United States Environmental Protection Agency's definition of a HEPA vacuum cleaner (100% leak tested to 99.97% @ 0.3 micron Efficiency).
12.Place the power head back on the container, and secure into place using CAUTION: This vacuum cleaner has been specifically designed to the 2 side latches. (fig. 14) clean up hazardous dust. Special filters reduce the incidence of airborne 13.Insert the large end of the hose into the front inlet of the tank and turn to dust that would be created by other methods of cleaning.
5. Plug the power cord in to the power outlet. (fig. 5) 4. Ensure that the switch is in the “O” position before plugging the power 6. Turn the motor on by flipping the switch to the “I” position. (fig. 6) cord into the power outlet.
NOTICE! 1. Ensure that the power cord is disconnected from the outlet. (fig. 1) 2. Disconnect the hose from the tank. (fig. 2) The filter included is made of high-quality material designed to stop small 3. Undo the clasps and remove the top section from the tank. (fig. 3) dust particles.
ROUBLESHOOTING WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE TROUBLESHOOTING. Corrective Action Symptom Possible Causes 1) No power supply. 1) Check power supply – cord, breakers, fuses. Wet/Dry 2) Faulty power cord. 2) Unplug and check the power cord. If Vacuum will 3) Tank full.
Page 10
DUST BAGS, FILTERS & ACCESSORIES always available from : cleva-uk.com VJE1650SW...