Warranty - Vacmaster VJE1650SW Manual

CAUTION:
This vacuum cleaner has been specifically designed to
clean up hazardous dust. Special filters reduce the incidence of airborne
dust that would be created by other methods of cleaning.
During the removal of hazardous dust, DO NOT sweep, scoop, shovel or in
any manner handle other than by vacuuming. DO NOT at any time attempt
to remove, substitute or by any other means modify the filters in the
vacuum cleaner.
Use only manufacturer's approved vacuum filters and filters bags. Before
attempting to use or before cleaning with this vacuum cleaner, be sure that
you fully understand the instructions for setting up or cleaning/changing
filters.
UNPACKING YOUR WET AND DRY VACUUM CLEANER & GENERAL
ASSEMBLY
1. Ensure that the power cord is disconnected from the power outlet. (fig. 1)
2. Undo the latches. (fig. 2)
3. Lift the top section off the tank. (fig. 3)
4. Remove the contents from inside the tank. (fig. 4)
5. Turn the container upside down. Insert the two casters into the sockets on
the bottom of the base and apply pressure until casters snap into place.
(fig. 5)
6. Insert the rear wheel shaft into the rear support block. Slide washer onto
the shaft, then install rear wheel onto the shaft. Slide washer onto the
shaft, then insert cotter pin into the hole at the end of the wheel shaft.
Bend the ends of the cotter pin around the shaft to secure. Snap the hub
cap onto the wheel. Repeat the same steps for the opposing wheel.
(fig. 6)
7. Position the hose storage rack as illustrated. Insert one side of the rack
into the channel, making sure it is secured in place. Squeeze in the other
end and insert it into the corresponding channel, making sure it is secured.
(fig. 7)
8. Insert the main handle into the handle socket mounted on the tank body.
Push down until the lock pin clicks in place. (fig. 8)
9. For dry vacuum cleaning, install the supplied pre-filter cartridge filter and
dust bag. (fig. 9 &10 & 11)
10.For wet vacuum cleaning, install the supplied foam filter. (fig. 12)
11.Replace the top section on the tank. (fig. 13)
12.Place the power head back on the container, and secure into place using
the 2 side latches. (fig. 14)
13.Insert the large end of the hose into the front inlet of the tank and turn to
lock. (fig. 15)
14.Fit the required accessory onto the suction tube. (fig. 16)
WARNING:
IF FILTERS ARE CONTAMINATED OR HAVE BEEN USED, THEY MUST BE
DISPOSED OF PROPERLY, PRIOR TO PERFORMING WET VACUUMING OPERATIONS.
D
RY VACUUM OPERATION
Operating instructions – dry vacuuming.
1 2
6
WARNING:
Before starting please read, understand, and apply the safety
instructions in Section 1. Reminder: DO NOT vacuum hazardous substances. The
use of an incorrect dust bag will invalidate the warranty.
1. Ensure that the power cord is disconnected from the outlet. (fig. 1)
2. Ensure that the cartridge filter is completely mounted. Ensure that the
filter is inserted all the way. (fig. 2)
3. Put the Pre-filter on the tank, Replace the top section on the tank, and
secure it in place using the clasps. (fig. 3)
4. Insert the larger end of the hose into the front inlet on the tank and lock it
in place. Push the required attachment on to the free end of the hose or
extension. (fig. 4)
3 4 5
6