Verification Stamp - Konica Minolta 7145 Internet Fax / Fax Operations

Verification Stamp

When transmitting a fax via the RADF, a stamp can be affixed to the pages of the document
that have already been scanned, allowing you to confirm that these pages have been
scanned. The stamp is a pink circle, 3mm in diameter and affixed at the rear edge on the front
side of the original document. When both sides of a sheet are transmitted, the stamp is affixed
on the front side.
Front surface of
original document
Original document
transmitting direction
DETAILS
•
The stamp ink must be replaced when it runs out. When color of the verification stamp
becomes light, contact your service representative for a replacement.
•
When mixed original mode is selected, no stamp may be affixed to the above position.
•
Even though the Verification Stamp function has been set, no Verification Stamp is put
though the document is transmitted through multi-feeding. In such a case, transmit the
document again.
•
Check if the document was correctly transmitted by the Transmission Report or Transmit
Result of the CHECK MODE.
•
For detail about replacing the stamp, refer to "Replacing the Stamp" (p. Appendix-5).
Setting Transmission Conditions - (continued)
Stamp position
Simple Internet
Fax Transmission
Transmitting Documents to
Internet Fax/Computer
Transmitting to Both
Conventional Fax and E-Mail
Placing the Original
on the Machine
Setting Transmission
Conditions
Met h od for Specifying
Addresses
Scanning
Canceling
Transmission
Confirming Reserved
Documents
Confi r mi n g
Communicati o n Results
2-25